AdapterId 080FDh
;;;
;
;   Rev 1.5 - 15 JUN 93 - added back in the VGA BIOS memory address ranges.
;			  This will cause setup conflicts in machines
;			  that have their motherboard SCSI adapter BIOSes
;			  fixed at address C0000.
;
;   Rev 1.4 - 14 JUN 93 - modified the I/O and memory addresses sepcified
;			  to allow installation in the Model 8556/9556
;			  machines that do not normally allow the motherboard
;			  video adapter to be overridden.
;
;    !!! WARNING: NEVER USE AUTOMATIC SETUP CONFIGURATION WITH THIS BOARD
;		  INSTALLED.  Most automatic setup routines cannot handle
;		  adapters that support multiple channels switched into
;		  the same IO/memory address range.
;
;;;

AdapterName  "STB MC/MVP ERGO VGA Adapter"

NumBytes 4

FixedResources
		     pos[0]=XX11XXXXb
		     pos[1]=XXXXXXXXb
		     pos[2]=00000000b
		     pos[3]=11XXXXXXb

;
;   The IO addresses shown below are basically used to cause the Automatic
;   Configuration to assign unique (hopefully sequential) board numbers
;   to each board.
;
;   The board also uses addresses 3C0-3DF just like a regular VGA.
;   These addresses cannot be sepcified in this ADF because of problems
;   with MicroChannel machines that do not properly handle add-in video
;   cards (such as the IBM model 8556/9556 machines.  The same can apply
;   to the video ROM BIOS buffer address range of C0000-C7FFF.
;

NamedItem
   Prompt  "Board number"
      Choice "1,2" pos[0]=XXXX000Xb   pos[3]=XX010000b
	 io 0FC2h-0FC3h  0C3C2h-0C3C3h
	 mem 0C0000h-0C7F9Fh
      Choice "3,4" pos[0]=XXXX010Xb   pos[3]=XX11XXXXb
	 io 0FC0h-0FC1h  0C3C0h-0C3C1h
	 mem 0C7FA0h-0C7FBFh
      Choice "5,6" pos[0]=XXXX100Xb   pos[3]=XX11XXXXb
	 io 0FC4h-0FC5h  0C3C4h-0C3C5h
	 mem 0C7FC0h-0C7FDFh
      Choice "7,8" pos[0]=XXXX110Xb   pos[3]=XX11XXXXb
	 io 0FC6h-0FC7h  0C3C6h-0C3C7h
	 mem 0C7FE0h-0C7FFFh


   Help
      "This allows support for multiple boards to be installed
      in your system.  Each STB video board must have a unique
      board number assigned to it.  Board numbers must be assigned
      sequentially starting at BOARD 1.  The Video BIOS for all
      boards is accessed only from BOARD 1."


NamedItem
   Prompt  "Clock frequency group select"
      Choice "Normal   " pos[0]=11XXXXXXb
      Choice "Ergonomic" pos[0]=00XXXXXXb

   Help
      "Selects one of two possible video frequency sets, Normal
      for most monitors, Ergonomic for high refresh ergonomic
      monitors ( *** Danger ---> Ergonomic frequencies can do
      permanent damage to some monitors. Consult manual. *** )"