Cirrus Logic 546X README.TXT
04/14/97

MICROSOFT WINDOWS 95 DRIVER INSTALLATION
------------------------------------------------------------
The Microsoft Windows 95 display driver works with Microsoft 
Windows 95 and supports 3D DirectDraw. Before starting, make 
a backup copy of the Windows 95 Driver diskettes using the 
DOS DISKCOPY command, and put them in a safe place.


WINDOWS 95 DRIVER INSTALLATION

Once Windows 95 has been installed on your system, follow 
the procedure listed below to install the Microsoft Windows 
95 display driver.

1.  Right click on the Windows 95 desktop (the Windows 
    background where no windows or icons are displayed) and 
    select Properties.

2.  At the top of the dialog box, click on the Settings tab.

3.  At the bottom of the Settings display screen, click on 
    the Change Display Type button.

4.  Click on the Change button adjacent to the Adapter Type 
    box.

5.  In the Select Device display screen, click on the Have 
    Disk button.

6.  Insert the driver diskettes labeled 'Windows 95 Driver, 
    1 of 2' in drive A: and follow the on-screen instructions. 
    The Windows 95 driver will be installed in the Windows 95 
    System directory.

7.  If 3D DirectDraw has previously been installed on your 
    system, the Windows 95 driver is now ready to run. If 3D 
    DirectDraw has not been installed, you will need to reboot 
    your system again to initialize the driver.

To configure the Windows 95 driver, follow the procedure 
listed in the next section, Configuring the Windows 95 Driver.


CONFIGURING THE WINDOWS 95 DRIVER

To configure your Windows 95 driver once it is installed, 
follow the procedure listed below.

1.  Right click on the Windows 95 desktop (the Windows 
    background where no windows or icons are displayed) 
    and select Properties.
 
2.  From the Display Properties dialog box, you can change 
    your driver and monitor configurations. 

    *  To change your Windows 95 driver configuration, 
       click on the Refresh tab button located at the top 
       of the dialog box and adjust the settings.

    *  To change your Windows 95 monitor configuration, 
       click on the Settings tab located at the top of the 
       dialog box and adjust the settings.

3.  Follow the on-screen prompts to complete the Windows 95 
    driver or monitor configuration.


Please see the PROPEN.DOC file for an updated listing of know problems.


- End of File -
